Introduction
Introduction Statistics Contact Development Disclaimer Help
Post AfGdyIQIDwvJftdjvc by [email protected]
More posts by [email protected]
Post #AfFhFkMPiCVlwrsVvM by [email protected]
0 likes, 0 repeats
i remember being a high schooler who was like "i wanna make a pcb owo&quot…
Post #AfFhaYNPSlnsrWGWZc by [email protected]
0 likes, 0 repeats
@whitequark I've designed a couple of PCBs but I almost always ended up bei…
Post #AfFhaYRJEGvH3c5deS by [email protected]
0 likes, 0 repeats
@astrid why
Post #AfGdyIQIDwvJftdjvc by [email protected]
0 likes, 0 repeats
@whitequark i remember designing my first pcb too. i used eagle too, it was eas…
Post #AfGdyIUXy8KHt5d8Yi by [email protected]
0 likes, 0 repeats
@electronic_eel yep, i had a similar experience
Post #AfGelYFaAQzOx47JEe by [email protected]
0 likes, 0 repeats
@whitequark Allium CircuitMaker was, fine, but i used low temp solder paste to …
Post #AfGhKFZzmCTn5aL2Y4 by [email protected]
0 likes, 0 repeats
@electronic_eel i didn't have any money so i eventually tried to do toner t…
Post #AfGhtsYcqivu71gdbE by [email protected]
0 likes, 0 repeats
@whitequark back when i tried it (end of Gymnasium / high school), qfn was mayb…
Post #AfGhtscsauKsKDg2EK by [email protected]
0 likes, 0 repeats
@electronic_eel I've used plenty of DIP devices, but I wanted to get into R…
Post #AfGjXRwnIwph7UQM0u by [email protected]
0 likes, 0 repeats
@whitequark I was lucky enough to have legit (although borrowed) NI Multisim an…
Post #AfGjXS1338EfKgPke0 by [email protected]
0 likes, 0 repeats
@gsuberland my father was an EE too, which in practice meant that he downloaded…
Post #AfGjXSJTwaysFr2TNQ by [email protected]
0 likes, 0 repeats
@whitequark actually the *first* EDA software I used was ISIS Lite. unsurprisin…
Post #AfH4crgZ8UHjQmFyfQ by [email protected]
0 likes, 0 repeats
@whitequark Aren’t they *all* objectively awful? I have done one workshop at …
You are viewing proxied material from pleroma.anduin.net. The copyright of proxied material belongs to its original authors. Any comments or complaints in relation to proxied material should be directed to the original authors of the content concerned. Please see the disclaimer for more details.