tfurrows, re: measuring for outlets, light fixtures, etc.
To begin with, here are some general principles: think of
everything as a grid. Rely on a square to find the positions
in the grid.
Here's a little ASCII art depicting a traditional L-shaped
square to convey the general idea of what follows. But it
really helps to have a full size (48") drywall T-square for
doing this.
Install panels until you get close to the proposed cut-out.
Let's say that you're installing the panels vertically and
you've installed panels from left to right along a wall.
Put one side of your square against the right edge of the
neighbouring panel and line the other up with the bottom of
the fixture that you need to cut a hole for. Then:
1. Using a pencil, mark the point on the neighbouring panel
parallel to the bottom of the fixture.
2. Using the measurements on the square, write down the
distance from the neighbouring panel to the close and far
edges of the fixture.
3. Move the square up to the top of the fixture. Mark the
point on the neighbouring panel parallel to the top of the
fixture.
4. Measure the distance from the bottom of the neighbouring
panel to your two marks.
Now, when you measure for the hole on the new panel, the
distances you measured up the neighbouring panel are the
measurements (from the bottom of your panel) for the bottom
and top of your hole. The distances that you measured over
from the neighbouring panel in step two are measurements
from the left side of the panel to the the sides of your
hole. If you just draw out the lines on the new panel (using
the square), they will intersect at all the corners.
If your hole is round, find an appropriately sized container
lid and center it inside the lines. Then trace around it. If
the hole is hexagonal, just wing it by drawing in the cuts
across the corners (or grab another electrical box and trace
around it).
You can also make all of the measurements out of a corner,
or from the ceiling downwards, etc.