Subj : Telnet on Arca
To   : Rick Smith
From : Kevin Nunn
Date : Sat Nov 21 2020 04:27 pm

Hello Rick.

17 Nov 20 14:50, you wrote to me:

KN>> REM SIO Setup
KN>> DEVICE=c:\sio\sio.sys (COM1:115200,INTERNET:3F8,4,-)
KN>> (COM2:115200,INTERNET:2F8,3,-) (COM3:115200,INTERNET:3E8,4,-)
KN>> (COM4:115200,INTERNET:2E8,3,-)
KN>> DEVICE=c:\sio\vsio.sys
KN>> DEVICE=c:\sio\vx00.sys

RS> Thankyou for that... I did try your config lines with vsio2k and
RS> crashed system... So I installed 160 and it seems to boot fine and
RS> claims to be running... when I run vmodem from a command prompt it
RS> loads and says that it is fine.. So setting those com ports to
RS> "internet" is that the only variable? Is there no where to mention
RS> telnet and perhaps a port? or does it just listen for any traffic?  So
RS> far I can get it to react to an incoming telnet....

It should automagically grab port 23 and the first connection will connect it
to COM1, and if another connection comes it it goes to COM2, etc.

Vmodem should load with 4 lines on top for each of the com ports. And when
someone attempts to connect to the port, it should show the incoming connection
below that. It shows the IP and the port it is assigned to.

Is it showing any of that?

Kevin

--- GoldED+/EMX 1.1.4.7
* Origin: Razor's Domain/2 BBS - bbs.razorsdomain.com:23230 (1:19/50.1)

You are viewing proxied material from vert.synchro.net. The copyright of proxied material belongs to its original authors. Any comments or complaints in relation to proxied material should be directed to the original authors of the content concerned. Please see the disclaimer for more details.