Subj : Telnet on Arca
To   : Kevin Nunn
From : Rick Smith
Date : Tue Nov 17 2020 02:50 pm

Greetings Kevin!

Tuesday November 17 2020 10:44, you wrote to me about an urgent matter!:

KN> Hello Rick.

KN> 14 Nov 20 08:33, you wrote to all:

KN> I am using v1.60 and here is my entries into config.sys. I am not sure
KN> if 2k works the same or not, But this might get you headed in the
KN> right direction.

KN> REM SIO Setup
KN> DEVICE=c:\sio\sio.sys (COM1:115200,INTERNET:3F8,4,-)
KN> (COM2:115200,INTERNET:2F8,3,-) (COM3:115200,INTERNET:3E8,4,-)
KN> (COM4:115200,INTERNET:2E8,3,-)
KN> DEVICE=c:\sio\vsio.sys
KN> DEVICE=c:\sio\vx00.sys

Thankyou for that... I did try your config lines with vsio2k and crashed system... So I installed 160 and it seems to boot fine and claims to be running... when I run vmodem from a command prompt it loads and says that it is fine.. So setting those com ports to "internet" is that the only variable? Is there no where to mention telnet and perhaps a port? or does it just listen for any traffic?  So far I can get it to react to an incoming telnet....

ANyhow thank you I am another step further I suppose...



----
Regards,


Rick Smith (Nitro)

... A job is nice, but it interferes with my BBSing...
--- GoldED+/LNX 1.1.5-b20180707
* Origin:  ----> Abacus Sysop Point --->>>>bbs.abon.us:2323  (1:105/10.1)