Subj : MBSE and Xinetd in new setup.
To   : All
From : Gert Andersen
Date : Wed Mar 16 2016 11:00 am

Hello All!

I have reinstall a new system on my fido2 pc with Gentoo and this is now
changed from using eth0 to enp2s0 in interface card and after installing xinetd
is xinetd not start in reason of it like to use the old eth0 so my mbse it not
right working self if it polls out but not running right as it should for the
telnet connection to get the sysop as first user for mbsebbs and linux user.
I have tried to find out where I in linux config files shall change eth0 to be
enp2s0.
There is then 2 choise there is either.
1. make linux use the old eth0
2. get changed xinetd to use enp2s0 instead of eth0.

It is just the newuse of interface keep going changed eth0 to enp2s0 and change
it again to eth0, self if I try to make linux to keep it to be eth0.

 Take care,
           Gert

     - Get the best with linux -

--- Msged/LNX 6.2.0 (Linux/2.6.39-gentoo-r1 (x86_64))
* Origin: * One bird in hand is better than 10 on the roof * (2:230/150)

You are viewing proxied material from vert.synchro.net. The copyright of proxied material belongs to its original authors. Any comments or complaints in relation to proxied material should be directed to the original authors of the content concerned. Please see the disclaimer for more details.