Subj : SEXPOTS - Pulling my hair out... :)
To   : Digital Man
From : cafarmer
Date : Mon Jun 10 2024 12:26 pm

I tried both AT&C1 (it was a suggested init string for the optima AT&C1&D2) and
ATC1. The modem didn't like AT&C1 - Error.

I cannot find the manual for the HSM 1200. But I did find the manual for the
HSM 300 and a General Smartmodem Guide.

D.5.1 Using the CD line
If you are confident of the communications environment and cabling
requirements, and have access to the RS-232 signal status, then monitoring the
CD line is the easiest carrier loss detection method to implement. This
requires &C1 to be programmed at setup time, or be stored in the modem as the
value recalled on reset or powerup.
However, this is the most restrictive and risky choice. It requires a properly
wired cable and support of &C1 by the modem's command set or proper DIP- switch
settings.

Since there may be some confusion on my part between ATC1 and AT&C1, I'm not
exactly sure if this text applies now:

Cn - Controls 
Smartmodem’s
 transmitter carrier; i.e.,
signal sent
when
 calling, answering or 
connected to a distant modem.
Default C=1
n = 0 Transmitter Off
n = 1 Transmitter On

So this was for the HSM 300 that came before the HSM 1200... I would be
surprised if most of the commands were not supported in the HSM 1200.

ATC1 = OK (not sure what this does. ATC? returns 000)
AT&C1 - ERROR

You are viewing proxied material from vert.synchro.net. The copyright of proxied material belongs to its original authors. Any comments or complaints in relation to proxied material should be directed to the original authors of the content concerned. Please see the disclaimer for more details.