TNC_PI:  A WIFI ENABLED TNC FOR AMATEUR RADIO
(Posted 2016-05-03 09:00:53 by corey_reichle)

So, I wanted a wifi-enabled TNC for mobile packet use, and for tooling
around at home, while not in the shack.  I also figured eventually, I'd
want to not do this all by hand, and I figured others would likely want to
do so as well.

So, I've release the tnc_pi project into the wild on Github.  Pulls are
welcomed, as well as suggestions and enhancements.

You can find the project here:
https://github.com/coreyreichle/tnc_pi [
https://github.com/coreyreichle/tnc_pi ]

Down the road, what I'd like to add simple web interface to configure
direwolf's modem.  Shouldn't be too difficult, but it'd take a little work.
 Until then, configuration via the command line isn't insane or anything
really.  The config is pretty simple to read.

--------

There is 1 comment on this post:

Comment #1 by RX-Only APRS iGate, And Future Plans For Packet Node –
Corey Reichle (  ) on 2016-05-11 02:37:01
[...] So, I've deployed an receive-only iGate for the APRS system.  It's
not very impressive as of now, an old RadioShack Pro-2023 scanner, with the
audio cable going to a Raspberry Pi running tnc_pi. [...]


To submit a comment on this post, email [email protected] or visit us
on the web [ https://www.coreyreichle.com ].

You are viewing proxied material from tilde.team. The copyright of proxied material belongs to its original authors. Any comments or complaints in relation to proxied material should be directed to the original authors of the content concerned. Please see the disclaimer for more details.