Introduction
Introduction Statistics Contact Development Disclaimer Help
Little green lamp (4805916)
by akos boda (akosboda)
Download
Web page
Nice looking little 1W LED lamp, about half creditcard
size.
Parts : Phone battery 34x54x6mm max. size, power LED 1W
white, coolplate, reflector 22mm, USB connector,
resistors,TP4055, enamel wire 0.2mm, thin string.
Parts source : Aliexpress
The charge circuit is the TP4055 SMD chip. The charge
current is adjusted to 100mA.
There is very little room for parts, please follow these
instructions. Cut a perfboard with 3x2 pads. Bend up pin2
of the chip, solder pins 3-4-5 on the board (pin 1 is
NC). Solder a short wire to pin3, feed it through the PCB
to the other side, solder 1uF on the other side to pin 3.
Same time, solder this wire to the flashlight switch's
side tab. Solder 1uF 0805 to pin 4 and 10kohm 0603 to pin
5. Solder a thin wire to pin2 and pull it to the other
side of the PCB connecting the 1uF there and coming back
to the 10kohm GND point. This way the whole assembly is
not thicker than 3 mm. Follow the schematics for the rest.
Charger circuit too complicated ? see the simple version
with diode + resistor. Slow, and the charger voltage must
be exact 5.0V. Charger current drops to 5mA at the end.
All parts must lay flat, or the battery won't fit. Check
the charge current. Pull the carry string in and tie a
knot.
The LED current is 200-300mA, giving 2-3 hours continous
bright light with a full charge.
The back cover has wedge sides, take care when sliding it
in. Notch is USB side.
GreenLampV3.stl is a version for slightly wider (36mm)
batteries.
Date Published: 2021-05-01 05:45:33
Identifier: thingiverse-4805916
Item Size: 1571714
Media Type: data
# Topics
stl
DIY
LED_light
3D_printing
torch
thingiverse
Rechargeable
# Collections
thingiverse
# Uploaded by
@xtream1101
# Similar Items
View similar items
PHAROS
You are viewing proxied material from tilde.pink. The copyright of proxied material belongs to its original authors. Any comments or complaints in relation to proxied material should be directed to the original authors of the content concerned. Please see the disclaimer for more details.