AX2 2 speed gearbox cover + servo mount (2775925)

	AX2 2 speed gearbox cover + servo mount (2775925)
	by Not Fill (Woyta)
	Download
	Web page

	I have bought AX2 2-speed gearbox for my Axial SCX10. I
	found out that holes of original Axial gerbox cover does
	not line up with mouting holes on AX2. And mount for 50g
	servo is to long for my Proline Chevrolet Silverado body.
	I think that problem will be common for Honcho, Ford F150
	or similar bodies. So I designed cover that will fit and
	servo mount for 9g servo. Servo mount is bigger than it
	should be but I am using it as a platform for mounting my
	ESC. Cover itself also could be bit slimmed but I keep it
	on safe side so there should be no contact between gears
	and wall.

	I have printed it from clear PETG on my Anet A8 with
	0,5mm jet.I am still tuning setting for PETG but after
	little bit it fits nicely under motor mount.

	You will need 6x screw M3x8, 3x M3 nut and 2x screw
	M3x25. These two replace 2x M3x20 that hold motor mount
	on gearbox and will be short after you put cover base
	under motor mount. You will probably need them cut to
	M3x22. But with stock clutch mount it could be OK. I am
	using solid mount that is closer to gearbox. So I had to
	cut them to correct lenght.

	Update:
	-Uploaded version 3. In this version there is bit less
	space for spur gear but if your spur gear is not sticking
	out from gearbox to much it should be OK. Reason for this
	modification is battery mounted in front of transmission.
	Second modification is more sturdy base with lip. First
	vesrsion was not sturdy enough and bend a little. That
	caused gap between booth parts. So new version got
	thicker edge and booth parts are now overlapping.

	Update2:
	-Fixed wrong filename AX2-V3-8MM to AX2-V3-10MM. This is
	version for standart driveshafts.
	-Uploaded version 3 for driveshafts with diameter 12mm.
	My new MS Technology (http://www.mstechnology.cz) does
	not fit in space given by standart 10mm driveshafts.
	Actualy distance between stock spur and closest poit on
	driveshaft is only 1,3mm! Only option is to make wall
	thin as possible or put hole in there. I were able to
	position 0,5mm wall in space where it seems that spur or
	driveshaft does not come in contact with spur or
	driveshaft. This variant I consider experimental. Seems
	to be working but your experience could be different.

	Date Published: 2021-04-17 20:20:45
	Identifier: thingiverse-2775925
	Item Size: 1161717
	Media Type: data

	# Topics
	transmission
	Axial_Scx10
	ax2
	thingiverse
	stl
	scx10
	RC4WD
	Axial
	R/C Vehicles

	# Collections
	thingiverse

	# Uploaded by
	@xtream1101

	# Similar Items
	View similar items

	PHAROS