Connectix RAM Doubler 8, version 8.0.1. RAM Doubler 8 is a form of RAM
virtualization software for Macintosh computers that have less than
256 MB of physical RAM installed.

RAM Doubler 8 is not a solution for applications that individually
require more memory than is currently installed as physical RAM. For
example, a configuration with 8 MB of physical RAM installed should
not attempt to run an application that requires 10 MB of RAM, even
with RAM Doubler installed. The virtualized memory that RAM Doubler 8
provides is best utilitized for running multiple smaller applications
simultaneously.

Top DL: A Disk Copy 4.2 image file of a 800k DD floppy disk,
compressed as StuffIt v5.5 ".sit" archive. Use same or Disk Copy 6.3.3
to write back to 800k floppy media.

2nd DL: Patched copy of the same, to allow installing without
requiring a floppy disk drive.

See also
[RAM Doubler 1.0][1]
[RAM Doubler 2][2]
[RAM Charger][3]

Compatibility
Architecture: 68k PPC

Suitable for Mac OS 7.1 through 8.6 with 32-bit addressing turned on
with a Motorola 68030 CPU or better, or a PPC Macintosh.

Top DL only: This software must be installed from a hardware floppy
disk to install. During installation the installer checks for the
presence of being run from a physical hardware floppy drive and will
not install otherwise.

With 84 MB RAM or more installed, RAM Doubler 8 extends memory up to
256 MB on 68K processor configurations or 240 MB on PowerPC
configurations (16 MB is reserved for File Mapping on PowerPC).

Not suitable for Macintosh emulators.

  [1]: http://macintoshgarden.org/apps/ram-doubler-101102
  [2]: http://macintoshgarden.org/apps/ram-doubler-2
  [3]: http://macintoshgarden.org/apps/ram-charger-301

You are viewing proxied material from phytocodex.porcupine.club. The copyright of proxied material belongs to its original authors. Any comments or complaints in relation to proxied material should be directed to the original authors of the content concerned. Please see the disclaimer for more details.