This unaltered story was originally published by U.S. NASA Space Agency.
URL: https://www.nasa.gov
Content is in public domain.

------------



ISS Daily Summary Report – 9/16/2021 – ISS On-Orbit Status Report

[]

Date: 2021-09-16 00:00:00

Payloads

Four Bed CO 2 Scrubber: The crew continued with the installation of the Four bed CO 2 Scrubber hardware by connecting power, data, and fluid lines. Four Bed CO 2 Scrubber demonstrates a technology for removing carbon dioxide (CO 2 ) from the atmosphere on a spacecraft. The technology is based on the current system in use on the ISS with mechanical upgrades in absorption beds, heater elements, and valves and use of an improved zeolite absorbent to reduce erosion and dust formation. A goal for next-generation systems is continuous operation for 20,000 hours without a failure, and this technology is a step toward that goal.

Light Ions Detector for ALTEA (LIDAL) Relocate 3: The crew placed the Light Ions Detector into its third configuration and installed a Radiation Environment Monitor (REM) detector on the Light Ions Detector. LIDAL is typically relocated roughly every 6 months to monitor different areas. The capability of the original Anomalous Long Term Effects in Astronauts (ALTEA) to measure the Linear Energy Transfer (LET) of protons and helium and the kinetic energy of protons and heavy ions was upgraded by the addition of the Time of Flight (TOF) system detector called LIDAL. LIDAL upgrades the ability of ALTEA to make measurements that can be converted, by dedicated software in real-time, into radiation risk coefficients – effectively enabling ALTEA to become the first ever dosimetric “risk meter” aboard the ISS.

NanoRacks Module-9: The crew gathered tubes 1, 2, 5, 6, 7 from Nanoracks Module-9 box s/n 1053, opened the green clamps on the tubes 2 and 7 and shook them to activate them. The crew held tubes 5 and 6 up to the video camera for observation, and opened the blue clamp on tube 1 to deactivate it. Following these activites, all five tubes were restowed. NanoRacks Module-9 consists of multiple student experiments housed within a NanoRacks Module container in individual mixture tubes. Some experiments require crew interaction to remove clamps in order to mix materials to activate and/or deactivate the experiments. The experiments within the module are returned to the ground for analysis

Standard Measures: The crew collected body, saliva, and fecal samples in support of the Standard Measures investigation. The aim of the investigation is to ensure consistent capture of an optimized, minimal set of measures from crewmembers until the end of the ISS Program in order to characterize the adaptive responses to and risks of living in space. Among other things, the ground teams perform analyses for metabolic and chemistry panels, immune function, microbiome, etc. These measures populate a data repository to enable high-level monitoring of countermeasure effectiveness and meaningful interpretation of health and performance outcomes, and support future research on planetary missions.

The ISS Experience: Following the extension of the JEM Airlock slide table into the JEM cabin, the crew removed the hardware used to support the ISS Experience EVA video events. The ISS Experience Z-Camera was most recently used to capture five events related to the United States On-orbit Segment (USOS) Extravehicular Activity (EVA) on Sunday, September 12th. The ISS Experience is a cinematic virtual reality (VR) series documenting life and research aboard the space station. Filmed over multiple months, the immersive VR series documents different crew activities – from science conducted aboard the station to preparation for a spacewalk.

Turbine Ceramic Manufacturing Module (T-CMM): Following the processing run, the ceramic module was removed and stowed. Unfortunately, the ceramic module leaked during processing resulting in an incomplete print. T-CMM demonstrates manufacture of single-piece turbine blade/disk combinations (blisks) in microgravity for commercial use. Manufacturing blisks in space could produce parts with lower mass and residual stress, and higher strength than those made on Earth due to greatly reduced sedimentation of the solution in microgravity.

Systems

Post Extravehicular Activity Activities: Today, the crew completed several activities following the successful completion of the USOS 4A ISS Roll-Out Solar Array Prep EVA on Sunday September 12th. The crew started the second regeneration cycle of the Extravehicular Mobility Unit (EMU) Metal Oxide (METOX) canisters by baking out CO 2 in the METOX Regenerator Oven as well as installed the EMU Helmet Lights, EMU TV, and High Definition EMU Camera Assembly (HECA) onto an EMU Helmet.

Oxygen Generation System (OGS) Hydrogen (H 2 ) Sensor Orbital Replacement Unit (ORU) Remove & Replace (R&R): Today, the crew performed an R&R of the OGS H2 sensor and cleaned the associated Avionics Air Assembly (AAA) inlet. The H 2 sensor R&R is routine maintenance activity and is necessary due to nominal degradation of the H 2 sensor materials over time. Following today’s R&R, ground specialists will conduct a checkout of the new sensor.

Regenerative Environmental Control and Life Support System (ECLSS) Oxygen Generation Assembly (OGA) Sample: The crew obtained a sample from the OGA recirculation loop and performed conductivity measurements on the sample. The sample will also be returned to the ground for analysis. Periodic water samples are returned for chemical, particulate, and microbial analysis in order to determine when total organic carbon remediation should be implemented to avoid risk of irreversible contamination damage to the OGA.

Hatch Seal Inspection: The crew cleaned and inspected the Node 1 Forward, Nadir, and Lab Aft hatch seals, hatch plate sealing surfaces, and crank handles for damage or Foreign Object Debris (FOD) following the transfer of the Four Bed CO 2 Scrubber through the hatches.

Environmental Health System (EHS) Total Organic Carbon Analyzer (TOCA) Water Recovery System (WRS) Sample Analysis & Data Record: The crew performed an analysis of the water processing assembly (WPA) using the TOCA. The TOCA unit oxidizes organic carbon species present in the water to carbon dioxide gas and measures the concentration using nondispersive infrared spectroscopy. Analysis of the potable water using the TOCA occurs on a weekly basis.

Completed Task List Activities:

Radio Frequency Identification Logistics Reader (RFID) Troubleshooting

Today’s Ground Activities:

All activities are complete unless otherwise noted.

JEM Airlock and ACDU-RC Activation

PRO CIR Activation Commanding

Regenerative ECLSS OGS H 2 Sensor Replacement Support

Look Ahead Plan

Friday, September 17 (GMT 260)

Payloads:

Astrobee perching arm remove

BCM Robot Test

ESA EPO BLOB experiment conclude

FSL VMU2 Board Exchange

ISS Experience EVA Z-Cam relocate and data transfer

JEM Microbe Sample Collect

Lumina Deinstall and reinstall

SOUNDSEE T/S ops and stow

Standard Measures Saliva Collect and stow

Systems:

In Flight Maintenance (IFM) Waste and Hygiene Compartment (WHC) Urine Receptacle (UR) and Insert Filter (IF) Remove and Replace

Extravehicular Mobility Unit (EMU) Cooling Loop Maintenance Scrub Initiation

BEAM Hardware stow

Health Maintenance System (HMS) OCT2 Exam

Saturday, September 18 (GMT 261)

Payloads:

ISS Experience SSD changeout

Rodent Research Experiment 1B

Veggie Monitoring

Systems:

Crew off-duty

Sunday, September 19 (GMT 262)

Payloads:

Rodent Research-Demo 1 crew review

Systems:

Crew off-duty

Today’s Planned Activities:

All activities are complete unless otherwise noted.

[END]

[1] Url: https://blogs.nasa.gov/stationreport/2021/09/16/iss-daily-summary-report-9-16-2021/

Published by NASA.Gov

via Magical.Fish Gopher News Feeds:
gopher://magical.fish/1/feeds/news/nasa/