(C) Alec Muffett's DropSafe blog.
Author Name: Alec Muffett
This story was originally published on allecmuffett.com. [1]
License: CC-BY-SA 3.0.[2]


This evening’s 3D-Print: Wine Rack Stackers

2024-02-17 20:54:20+00:00

I have two 1990s vintage cheapo wine racks but an alcove which is only big enough to fit 1.6 of them; so I cut the bottom off of one using tin snips, and then 3D printed some butterfly ties so that they can be stacked on top of each other.

The tie has the same cross section as the wooden bars but rotated 45°, and then a couple of notches are removed from the tie, using the tie itself as a die to ‘cut’ out from the model.
[END]

[1] URL: https://alecmuffett.com/article/109194
[2] URL: https://creativecommons.org/licenses/by-sa/3.0/

DropSafe Blog via Magical.Fish Gopher News Feeds:
gopher://magical.fish/1/feeds/news/alecmuffett/

You are viewing proxied material from magical.fish. The copyright of proxied material belongs to its original authors. Any comments or complaints in relation to proxied material should be directed to the original authors of the content concerned. Please see the disclaimer for more details.