###################################
              DETH v4.01 and later Installation
             ###################################

Installation:
-------------

1) Create a new directory to install DETH in

2) Copy and unzip DETH.ZIP there (no -d required)

3) Edit DOOM2.CFG and/or DOOM1.CFG and change the [wad] entry to the path for
  the DOOM2.WAD and/or DOOM.WAD on your system.

4) Make sure the VESA driver for your video card is installed or that
  you are running UniVBE or SDD or one of the universal VESA drivers.

4) Type DETH to start the editor (CWSDPMI.EXE in zip must be in
  current directory or path if DPMI manager not supplied by other
  means).


Troubleshooting
---------------

1) If it says it can't find DOOM2.WAD or DOOM.WAD, check the path to
  DOOM2.CFG, DOOM1.CFG in  DETH.INI and insure it reads:

       #Path to config files
       Doom = doom1.cfg
       Doom2 = doom2.cfg

  Also check the [wad] entry in DOOM2.CFG or DOOM1.CFG and insure it'
  correctly locates your DOOM2.WAD or DOOM.WAD.

2) If the BOOM extended functions don't appear in the menus make sure
  DETH.INI has the Boom variable set to True. Running "DETH -boom" once
  should do this.

3) If the editor comes up - but most of the text is missing on the
  displays and menus, make sure DETH.FNT is in the directory you are
  running BOOM from.

4) Do not run DETH by double clicking DETH.EXE or a shortcut to it in
  Win'95 until you have created a shortcut, set the Program tab in
  the shortcut's properties to specify the DETH directory as the
  working directory, and set the Window properties to Full-Screen. You
  may not get fonts or load the config files properly otherwise. If you
  don't know how to edit shortcuts, start an MS-DOS prompt, make it
  full-screen with Alt-Enter, change to the DETH directory, and
  start DETH with a command line.

5) Write me at [email protected], and explain the problem.
  I'll do my best to get you running.