How To Use PC Pursuit Service
-----------------------------
Placing a PC Pursuit Call
-------------------------
* Use a modem to dial your local Telenet access telephone
number with parameters settings of 8-N-1.
* Type two CARRIAGE RETURNS (CR) D (CR)
Telenet Prompt User Input Comments
======================================================================
(1) Terminal = D1 (CR) Input Terminal ID.
D1 is typical for
PC's. If not known,
type CR.
(2) @ C D/NYNYO/12,YOUR ID (CR) Type area code desired,
modem speed and your
user ID. (Note that
/3 = 300 bps, /12 = 1200
bps, /24 = 2400 bps).
(3) PASSWORD = PASSWORD (CR) Enter user Password
(4) D/NYNYO/12 Connected to target
CONNECTED city outdial modem.
(5) ATZ Type ATZ (in upper case)
(6) OK Modem responds as cleared.
(7) ATDT 7654321 Type ATDT (in upper case)
and the 7-digit number
you wish to dial.
(8) CONNECT (CR) (CR) You are now connected to
the computer that you
dialed. Procees as if
the number was dialed
directly.
NOTES:
-----
1. If the connection was not made, a BUSY will be seen within 30
seconds. The BUSY message means that the number dialed was either
busy, not in service, or an invalid attempt to dial more than 7
digits. A BUSY will also be seen after disconnecting from the
host computer, but you can dial another number by starting again
at the fifth step and typing ATZ and dialing the number.
2. PC Pursuit uses standard HAYES dialing commands, which enable
you to type the A/ (no CR) command to redial the previously
dialed number.
3. When a typing mistake is made in the second and third steps,
the log-on must be re-entered.
To Disconnect from PC Pursuit
-----------------------------
Telenet Prompt User Input Comments
======================================================================
(CR) @ (CR) Escape to Telenet
command level.
@ D (CR) At the @ sign,issue
disconnect command.
D/NYNYO/12 Disconnect from the
DISCONNECTED target city complete.
User is still connected
to Telenet at the local
dial-up city. A PC Pursuit
can now be placed to
another city.
NOTES:
------
1. To DISCONNECT FROM TELENET, log off your computer as usual, or
hang-up.
