IF ---  The system fails to start executing the .INI file.
  THEN - The values for the ADIT base port and/or interrupt
         level probably conflict with your main boot device.

IF ---  The system stops during the TRMDEF statements.
  THEN - Check the ADIT switch settings for J2 (interrupt
         level) and J3 (port addresses). Be sure that these
         settings correspond to the values defined by the
         table called "CBITBL:" in ADIT.M68.

IF ---  The system stops while setting up the jobs.
       (ie: FORCE, ATTACH, etc)
  THEN - There may or may not be something wrong with
         the ADIT board.
IF ---  The system crashes during this test.
       CAUSES
       * There may be an interrupt or port conflict.

You are viewing proxied material from gopher.floodgap.com. The copyright of proxied material belongs to its original authors. Any comments or complaints in relation to proxied material should be directed to the original authors of the content concerned. Please see the disclaimer for more details.