 |
Return Create A Forum - Home |
 |
--------------------------------------------------------- |
|
Unimog Club UK |
 |
https://unimogclubuk.createaforum.com |
|
--------------------------------------------------------- |
|
***************************************************** |
|
Return to: Tutorials |
|
***************************************************** |
|
#Post#: 8267-------------------------------------------------- |
|
SBU cab tilt mech |
|
By: cir287 Date: May 21, 2020, 6:39 am |
|
--------------------------------------------------------- |
|
Attached is a drawing of a mechanism I built for tipping an SBU |
|
cab. The drawing isint completely dimensioned but feel free to |
|
ask if unsure. |
|
I've built and tested it, it works very well although I'd use an |
|
air tool to wind it, its tedious. |
|
No bending or flexing but I'd still use a chock and check strap |
|
when in raised position and needless to say dont be under it |
|
when raising / lowering. |
|
I built it for pennies, 2no 1m long M30 threaded bars 6no M30 |
|
nuts & washers (not sure of cost), 2no thrust bearings (~�5ea) |
|
and some scraps I had lying around. |
|
Ciaran |
|
#Post#: 8309-------------------------------------------------- |
|
Re: SBU cab tilt mech |
|
By: Unimob Date: August 8, 2020, 3:56 pm |
|
--------------------------------------------------------- |
|
Very good idea here. Works off the same principle as a vice only |
|
on a larger scale. I'm going to give this a go. |
|
Thanks Claran. |
|
***************************************************** |
