 |
Return Create A Forum - Home |
 |
--------------------------------------------------------- |
|
Chainsaw Repair |
 |
https://chainsawrepair.createaforum.com |
|
--------------------------------------------------------- |
|
***************************************************** |
|
Return to: Wanted |
|
***************************************************** |
|
#Post#: 80288-------------------------------------------------- |
|
McCulloch Gear Drive Parts |
|
By: weimedog Date: December 9, 2017, 8:16 am |
|
--------------------------------------------------------- |
|
Looking to either find a 19/31 ID "Spur" sprocket in .404 with 8 |
|
pins. OR a better B&C combo in 1/2 inch. I have 1/2 inch loops |
|
74 and 87 links. |
|
#Post#: 80301-------------------------------------------------- |
|
Re: McCulloch Gear Drive Parts |
|
By: Al Smith Date: December 10, 2017, 5:34 am |
|
--------------------------------------------------------- |
|
A similar inquiry was asked on another forum with a different |
|
user name .My suggestion is going with the .404 because of lack |
|
of 1/2" chain .However if you have the chain it's not that hard |
|
to adjust the driver count and if you have a chain punch you |
|
might be able to use the tie straps over if they punch out cjean |
|
.About any hard nosed McCulloch .063 bar for large framed saws |
|
should work on the gear drive . |
|
As I said on another forum,Bryce out in Marysville Washington |
|
occasionally sells .404 spurs on flea bay .I have his phone |
|
number . |
|
#Post#: 80405-------------------------------------------------- |
|
Re: McCulloch Gear Drive Parts |
|
By: pete Date: December 14, 2017, 5:19 am |
|
--------------------------------------------------------- |
|
Al so am I correct if I take bars from some of my mac 250s will |
|
they work on my 5 10 geardrive |
|
#Post#: 80422-------------------------------------------------- |
|
Re: McCulloch Gear Drive Parts |
|
By: Al Smith Date: December 14, 2017, 5:04 pm |
|
--------------------------------------------------------- |
|
No a 10 series bar only fits on a 10 series saw .Now some |
|
Husqvarna mounts will fit ,depends on who made them . |
|
#Post#: 80428-------------------------------------------------- |
|
Re: McCulloch Gear Drive Parts |
|
By: Al Smith Date: December 15, 2017, 5:21 am |
|
--------------------------------------------------------- |
|
There's another thing about older McCulloch hard nose bars and |
|
actually about any of them,10 series included .For reasons |
|
unknown to me these thing could come in about every gauge |
|
known,from .050 to .063 .I was given a 32" 10 series with a .404 |
|
sprocket nose in .050 gauge .I didn't even know they made .404 |
|
in .050 until then .I changed the nose to 3/8" |
|
The 48" McCulloch hard nose on that saw in my avatar is in .058 |
|
.I had a time even finding .404 in that gauge .I can't imagine |
|
it but I've learned they made 1/2" in .050 and .058 . |
|
I might mention that avatar saw also has a Stihl mount,066 size |
|
,36" .404 I adapted using spacers .Not all Stihl mounts would |
|
work because the tail section is too narrow .Adapting bars can |
|
be a chore at times but it can be done with a little luck . |
|
***************************************************** |
