* * * * *

                With a large enough hammer, anything will fit!

It's been a busy day.

I dropped Bunny off at the airport (she's flying out to Seattle [1] to visit
family) and by the time I got back to Casa New Jersey, Spring [2] had all the
supplies for all the electrical work [3] that needs done about the house.

The light switches (there were two being replaced) went quickly. The back
porch light fixture replacement was fairly straightforward, and thankfully,
the wasp nest inside had long been abandoned.

[These bastards didn't even have the courtesy to pay rent!] [4]
[5]

I can't say the same about the bathroom fan.

The fan unit itself came right out. So did the fan unit outlet. The fan unit
housing, on the other hand, required the application of a few screw drivers
(one mangled beyond use), a large hammer, a crowbar, and some cringe-worthy
damage along the ceiling before it was finally extracted whereupon we found
the second wasp nest of the day:

[Another colony of freeloaders] [6]
[7]

And much like the other one, this one had (thank God!) been abandoned as
well.

It was much to our disappointment that the replacement fan was ¼″ too large
to fit.

Sigh.

Meanwhile, The Monopolistic Phone Company found some round toits [8] and
managed to roll a truck out our way. Bob, The Monopolistic Phone Company
Technician got right to work on restoring our phone service. By the time
Spring and I realized the bathroom fan unit we had wouldn't fit, Bob had
finished connecting up our phone system and was going nuts trying to figure
out why the DSL (Digital Subscriber Line) wasn't working. We told Bob that
the DSL was off, since we flipped all the breakers.

But we did test the phone at least, and it was working. So the DSL should
(there's that word again) come up when we restored power. Bob left.

We also left. Spring and I headed over to Home Depot [9] to see if we could
get a bathroom fan that would fit.

We got there only to find out we were screwed. All the units were the same
size, meaning they were ¼″ too large. Actually, it was the fan unit housing
that was ¼″ too large—the fan unit itself would (just barely) fit. After
spending some time thinking about it, we decided to keep the unit we had, and
using some tin snips (which we purchased), cut the housing to fit.

And by God we got that fan unit to fit. I cut a quater inch off the fan
housing (basically, we removed one whole side), shove it into the space, then
with the application of a large hammer, somewhat forced the fan unit itself
into place (it was a very tight fit).

And by God if it didn't work too!

Woot!

And we have Intarwebs again!

Double woot!

[1] http://www.ci.seattle.wa.us/
[2] http://www.springdew.com/
[3] gopher://gopher.conman.org/0Phlog:2007/07/27.4
[4] gopher://gopher.conman.org/IPhlog:2007/07/28/t-p7280002.jpg
[5] gopher://gopher.conman.org/IPhlog:2007/07/28/p7280002.jpg
[6] gopher://gopher.conman.org/IPhlog:2007/07/28/t-p7280007.jpg
[7] gopher://gopher.conman.org/IPhlog:2007/07/28/p7280007.jpg
[8] gopher://gopher.conman.org/0Phlog:2007/07/27.7
[9] http://www.homedepot.com/

Email author at [email protected]