/*-
* Copyright (c) 1998 The NetBSD Foundation, Inc.
* All rights reserved.
*
* This code is derived from software contributed to The NetBSD Foundation
* by Paul Kranenburg.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
*
* THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS
* ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED
* TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
* PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS
* BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
* CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
* SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
* INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
* CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
* ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
* POSSIBILITY OF SUCH DAMAGE.
*/
/*
* DMAWAIT waits while condition is true
*/
#define DMAWAIT(SC, COND, MSG, DONTPANIC) do if (COND) { \
int count = 500000; \
while ((COND) && --count > 0) DELAY(1); \
if (count == 0) { \
printf("%s: line %d: CSR = 0x%lx\n", __FILE__, __LINE__, \
(u_long)L64854_GCSR(SC)); \
if (DONTPANIC) \
printf(MSG); \
else \
panic(MSG); \
} \
} while (/* CONSTCOND */ 0)
#define DMA_DRAIN(sc, dontpanic) do { \
uint32_t _csr; \
/* \
* DMA rev0 & rev1: we are not allowed to touch the DMA "flush" \
* and "drain" bits while it is still thinking about a \
* request. \
* other revs: D_ESC_R_PEND bit reads as 0 \
*/ \
DMAWAIT(sc, L64854_GCSR(sc) & D_ESC_R_PEND, "R_PEND", dontpanic);\
if (sc->sc_rev != DMAREV_HME) { \
/* \
* Select drain bit based on revision \
* also clears errors and D_TC flag \
*/ \
_csr = L64854_GCSR(sc); \
if (sc->sc_rev == DMAREV_1 || sc->sc_rev == DMAREV_0) \
_csr |= D_ESC_DRAIN; \
else \
_csr |= L64854_INVALIDATE; \
\
L64854_SCSR(sc,_csr); \
} \
/* \
* Wait for draining to finish \
* rev0 & rev1 call this PACKCNT \
*/ \
DMAWAIT(sc, L64854_GCSR(sc) & L64854_DRAINING, "DRAINING", dontpanic);\
} while (/* CONSTCOND */ 0)
#define DMA_FLUSH(sc, dontpanic) do { \
uint32_t _csr; \
/* \
* DMA rev0 & rev1: we are not allowed to touch the DMA "flush" \
* and "drain" bits while it is still thinking about a \
* request. \
* other revs: D_ESC_R_PEND bit reads as 0 \
*/ \
DMAWAIT(sc, L64854_GCSR(sc) & D_ESC_R_PEND, "R_PEND", dontpanic);\
_csr = L64854_GCSR(sc); \
_csr &= ~(L64854_WRITE | L64854_EN_DMA); /* no-ops on ENET */ \
_csr |= L64854_INVALIDATE; /* XXX FAS ? */ \
L64854_SCSR(sc,_csr); \
} while (/* CONSTCOND */ 0)
/*DMAWAIT1(sc); why was this here? */
csr = L64854_GCSR(sc);
csr &= ~L64854_RESET; /* de-assert reset line */
L64854_SCSR(sc, csr);
DELAY(5); /* allow a few ticks to settle */
/*
* the rules say we cannot transfer more than the limit
* of this DMA chip (64k for old and 16Mb for new),
* and we cannot cross a 16Mb boundary.
*/
*dmasize = sc->sc_dmasize =
uimin(*dmasize, DMAMAX((size_t)*sc->sc_dmaaddr));
/*
* Pseudo (chained) interrupt from the esp driver to kick the
* current running DMA transfer. Called from ncr53c9x_intr()
* for now.
*
* return 1 if it was a DMA continue.
*/
int
lsi64854_scsi_intr(void *arg)
{
struct lsi64854_softc *sc = arg;
struct ncr53c9x_softc *nsc = sc->sc_client;
char bits[64];
int trans, resid;
uint32_t csr;
resid = 0;
/*
* If a transfer onto the SCSI bus gets interrupted by the device
* (e.g. for a SAVEPOINTER message), the data in the FIFO counts
* as residual since the NCR53C9X counter registers get decremented
* as bytes are clocked into the FIFO.
*/
if (!(csr & D_WRITE) &&
(resid = (NCR_READ_REG(nsc, NCR_FFLAG) & NCRFIFO_FF)) != 0) {
DPRINTF(LDB_SCSI, ("%s: empty esp FIFO of %d ",
__func__, resid));
if (nsc->sc_rev == NCR_VARIANT_FAS366 &&
(NCR_READ_REG(nsc, NCR_CFG3) & NCRFASCFG3_EWIDE))
resid <<= 1;
}
if ((nsc->sc_espstat & NCRSTAT_TC) == 0) {
/*
* `Terminal count' is off, so read the residue
* out of the NCR53C9X counter registers.
*/
resid += (NCR_READ_REG(nsc, NCR_TCL) |
(NCR_READ_REG(nsc, NCR_TCM) << 8) |
((nsc->sc_cfg2 & NCRCFG2_FE) ?
(NCR_READ_REG(nsc, NCR_TCH) << 16) : 0));
if (resid == 0 && sc->sc_dmasize == 65536 &&
(nsc->sc_cfg2 & NCRCFG2_FE) == 0)
/* A transfer of 64K is encoded as `TCL=TCM=0' */
resid = 65536;
}
trans = sc->sc_dmasize - resid;
if (trans < 0) { /* transferred < 0 ? */
#if 0
/*
* This situation can happen in perfectly normal operation
* if the ESP is reselected while using DMA to select
* another target. As such, don't print the warning.
*/
printf("%s: xfer (%d) > req (%d)\n",
device_xname(sc->sc_dev), trans, sc->sc_dmasize);
#endif
trans = sc->sc_dmasize;
}
if (dodrain) { /* XXX - is this necessary with D_DSBL_WRINVAL on? */
int i = 10;
csr |= E_DRAIN;
L64854_SCSR(sc, csr);
while (i-- > 0 && (L64854_GCSR(sc) & D_DRAINING))
delay(1);
}
/*
* the rules say we cannot transfer more than the limit
* of this DMA chip (64k for old and 16Mb for new),
* and we cannot cross a 16Mb boundary.
*/
*dmasize = sc->sc_dmasize =
uimin(*dmasize, DMAMAX((size_t) *sc->sc_dmaaddr));