/*      $NetBSD: i82595reg.h,v 1.10 2008/04/28 20:23:50 martin Exp $    */

/*-
* Copyright (c) 1996 The NetBSD Foundation, Inc.
* All rights reserved.
*
* This code is derived from software contributed to The NetBSD Foundation
* by Ignatios Souvatzis.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
*    notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
*    notice, this list of conditions and the following disclaimer in the
*    documentation and/or other materials provided with the distribution.
*
* THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS
* ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED
* TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
* PURPOSE ARE DISCLAIMED.  IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS
* BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
* CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
* SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
* INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
* CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
* ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
* POSSIBILITY OF SUCH DAMAGE.
*/

/*
* Intel 82595 Ethernet chip register, bit, and structure definitions.
*
* Written by is with reference to Intel's i82595FX data sheet, with some
* clarification coming from looking at the Clarkson Packet Driver code for this
* chip written by Russ Nelson and others;
*
* and
*
* configuration EEPROM layout. Written with reference to Intels
* public "LAN595 Hardware and Software Specifications" document.
*/

/* registers */

/* bank0 */

#define COMMAND_REG 0   /* available in any bank */

#define         MC_SETUP_CMD    0x03
#define         XMT_CMD         0x04
#define         TDR_CMD         0x05
#define         DUMP_CMD        0x06
#define         DIAG_CMD        0x07
#define         RCV_ENABLE_CMD  0x08
#define         RCV_DISABLE_CMD 0x0a
#define         RCV_STOP_CMD    0x0b
#define         RESET_CMD       0x0e
#define         TRISTATE_CMD    0x16
#define         NO_TRISTATE_CMD 0x17
#define         POWER_DOWN_CMD  0x18
#define         SLEEP_MODE_CMD  0x19
#define         NEGOTIATE_CMD   0x1a
#define         RESUME_XMT_CMD  0x1c
#define         SEL_RESET_CMD   0x1e
#define         BANK_SEL(n)     (n<<6)  /* 0, 1, 2 */

#define STATUS_REG 1

#define         RX_STP_INT      0x01
#define         RX_INT          0x02
#define         TX_INT          0x04
#define         EXEC_INT        0x08
#define         EXEC_STATUS     0x30

#define ID_REG 2

#define         ID_REG_MASK     0x2c
#define         ID_REG_SIG      0x24
#define         R_ROBIN_BITS    0xc0
#define         R_ROBIN_SHIFT   6
#define         AUTO_ENABLE     0x10

#define INT_MASK_REG 3

#define         RX_STOP_BIT     0x01
#define         RX_BIT          0x02
#define         TX_BIT          0x04
#define         EXEC_BIT        0x08
#define         ALL_INTS        0x0f

#define RCV_START_LOW 4
#define RCV_START_HIGH 5

#define RCV_STOP_LOW 6
#define RCV_STOP_HIGH 7

#define RCV_COPY_THRESHOLD 8    /* byte */

#define XMT_ADDR_REG 0x0a
#define HOST_ADDR_REG 0x0c
#define MEM_PORT_REG 0x0e

/* -------------------- bank1 -------------------- */

#define REG1 1

#define         WORD_WIDTH      0x02
#define         INT_ENABLE      0x80

#define INT_NO_REG 2

#define RCV_LOWER_LIMIT_REG 8
#define RCV_UPPER_LIMIT_REG 9

#define XMT_LOWER_LIMIT_REG 10
#define XMT_UPPER_LIMIT_REG 11

/* bank2 */

/* reg1, apparently */

#define         XMT_CHAIN_INT   0x20    /* interrupt at end of xmt chain */
#define         XMT_CHAIN_ERRSTOP 0x40  /* int at end of chain even if err */
#define         RCV_DISCARD_BAD 0x80    /* Throw bad frames away and continue */

#define RECV_MODES_REG 2

#define         PROMISC_MODE    0x01
#define         NO_BRDCST       0x02
#define         NO_RX_CRC       0x04
#define         NO_ADD_INS      0x10
#define         MULTI_IA        0x20

#define         MATCH_ID        (NO_ADD_INS | NO_RX_CRC | NO_BRDCST)
#define         MATCH_BRDCST    (NO_ADD_INS | NO_RX_CRC)
#define         MATCH_MULTI     (NO_ADD_INS | NO_RX_CRC | MULTI_IA)
#define         MATCH_ALL       (NO_ADD_INS | NO_RX_CRC | PROMISC_MODE)

#define MEDIA_SELECT 3

#define         TPE_BIT         0x04
#define         BNC_BIT         0x20
#define         TEST_MODE_MASK  0x3f

#define I_ADD(n) (n+4)  /* 0..5 -> 4..9 */

#define EEPROM_REG 10

#define         EEDO 8
#define         EEDI 4
#define         EECS 2
#define         EESK 1

/*
* EEPROM layout. Written with reference to Intels public "LAN595 Hardware and
* Software Specifications" document.
*/

#define EEPPW0          0
#define         EEPP_BusWidth   0x0004
#define         EEPP_FlashAdrs  0x0038
#define         EEPP_FLASHTRANSFORM {-1, -1, 0xC8000, 0xCC000, 0xD0000, \
                                       0xD4000, 0xD8000, 0xDC000}
#define         EEPP_AutoIO     0x0040
#define         EEPP_IOMapping  0xfc00

#define EEPPW1          1
#define         EEPP_Int        0x0007
#define         EEPP_INTMAP     {9, 3, 5, 10, 11, -1, -1, -1}
#define         EEPP_RINTMAP    {0xff, 0xff, 0x02, 0x00, 0xff, 0x01, 0xff, \
                                0xff, 0xff, 0x02, 0x03, 0x04 }

#define         EEPP_LinkInteg  0x0008
#define         EEPP_PolarCorr  0x0010
#define         EEPP_AuiTpe     0x0020
#define         EEPP_Jabber     0x0040
#define         EEPP_AutoPort   0x0080
#define         EEPP_SmOut      0x0100
#define         EEPP_BootFls    0x0200
#define         EEPP_DramSize   0x1000
#define         EEPP_AltReady   0x2000

#define EEPPEther2      2
#define EEPPEther1      3
#define EEPPEther0      4

#define EEPPEther2a     0x3c
#define EEPPEther1a     0x3d
#define EEPPEther0a     0x3e

#define EEPPW5          5
#define         EEPP_BncTpe     0x0001
#define         EEPP_RomSlct    0x0006  /* none, NetWare, NDIS, rsrvd. */
#define         EEPP_NumConn    0x0008  /* 0=2, 1=3 */

#define EEPW6           6
#define EEPP_BoardRev   0x00FF

#define EEPP_LENGTH 0x40
#define EEPP_CHKSUM 0xBABA /* Intel claim 0x0, but this seems to be wrong */

#define RCV_NO_RSC_REG  11
       /* How many packets were dropped due to insufficient space */

/* ---- xmt /rcv /exec buffer format ---- */

#define I595_XMT_HDRLEN 8

#define CMD_MASK        0x001f
#define TX_DONE         0x0080
#define CHAIN           0x8000

#define XMT_STATUS      0x02
#define XMT_CHAIN       0x04
#define XMT_COUNT       0x06

#define I595_RCV_HDRLEN 8

#define RCV_DONE        0x0008
#define RX_OK           0x2000
#define RX_ERR          0x0d81