/*
* Copyright (c) 1996-99 Hauke Fath. All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
* 3. The name of the author may not be used to endorse or promote products
* derived from this software without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE AUTHOR ``AS IS'' AND ANY EXPRESS OR
* IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES
* OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
* IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
* NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
* DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
* THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
* (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
* THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*/
#ifndef _MAC68K_IWMREG_H
#define _MAC68K_IWMREG_H
/*
* iwmreg.h -- Interface declarations for iwm.
*/
/*
* Access
*/
enum {
noErr = 0, /* All went well */
noDriveErr = -64, /* Drive not installed */
offLinErr = -65, /* R/W requested for an offline drive */
noNybErr = -66, /* Disk is probably blank */
noAdrMkErr = -67, /* Can't find an address mark */
dataVerErr = -68, /* Read verify compare failed */
badCkSmErr = -69, /* Bad address mark checksum */
badBtSlpErr = -70, /* Bad address mark (no lead-out) */
noDtaMkErr = -71, /* Could not find a data mark */
badDCkSum = -72, /* Bad data mark checksum */
badDBtSlp = -73, /* One of the data mark bit slip */
/* nibbles was incorrect. */
wrUnderRun = -74, /* Could not write fast enough to */
/* keep up with the IWM */
cantStepErr = -75, /* Step handshake failed during seek */
tk0BadErr = -76, /* Track 00 sensor does not change */
/* during head calibration */
initIWMErr = -77, /* Unable to initialize IWM */
twoSideErr = -78, /* Tried to access a double-sided disk */
/* on a single-sided drive (400K drive) */
spAdjErr = -79, /* Can't adjust drive speed (400K drive) */
seekErr = -80, /* Wrong track number read in a sector's */
/* address field */
sectNFErr = -81, /* Sector number never found on a track */
fmt1Err = -82, /* Can't find sector 0 after track format */
fmt2Err = -83, /* Can't get enough sync */
verErr = -84 /* Track failed to verify */
};
#define IWM_TAG_SIZE 20 /* That's what "SonyEqu.a" says */
/*
* Cylinder cache data structure
* Cyl buffer is allocated in fdopen() and deallocated in fdclose().
*
* The "valid" flag is overloaded as "dirty" flag when writing
* to disk.
*/
struct cylCacheSlot {
unsigned char *secbuf; /* ptr to one sector buffer */
int32_t valid; /* content valid for cur. cylinder? */
};
typedef struct cylCacheSlot cylCacheSlot_t;
#else /* _LOCORE */
/*
* Assembler equates for IWM, kept here to ensure consistency.
* Modelled after <sys/disklabel.h>
*/
/*
* Offsets from IWM base address
* Lines are set by any memory access to corresponding address (IM III-34/-44).
* The SWIM has actual registers at these addresses, so writing to them
* in IWM mode is a no-no.
*/
.equ ph0L, 0x0000 /* CA0 off (0) */
.equ ph0H, 0x0200 /* CA0 on (1) */
.equ ph1L, 0x0400 /* CA1 off (0) */
.equ ph1H, 0x0600 /* CA1 on (1) */
.equ ph2L, 0x0800 /* CA2 off (0) */
.equ ph2H, 0x0A00 /* CA2 on (1) */
.equ ph3L, 0x0C00 /* LSTRB off (low) */
.equ ph3H, 0x0E00 /* LSTRB on (high) */
.equ mtrOff, 0x1000 /* disk enable off */
.equ mtrOn, 0x1200 /* disk enable on */
.equ intDrive, 0x1400 /* select internal drive */
.equ extDrive, 0x1600 /* select external drive */
.equ q6L, 0x1800 /* Q6 off */
.equ q6H, 0x1A00 /* Q6 on */
.equ q7L, 0x1C00 /* Q7 off */
.equ q7H, 0x1E00 /* Q7 on */
/*
* VIA Disk SEL line
*/
.equ vBufA, 0x1E00 /* Offset from vBase to register A */
/* (IM III-43) */
.equ vHeadSel, 5 /* Multi-purpose line (SEL) */
.equ vHeadSelMask, 0x0020 /* Corresponding bit mask */
/*
* Disk registers
* bit 0 - CA2, bit 1 - SEL, bit 2 - CA0, bit 3 - CA1 IM III name
*/
/* Status */
.equ stepDirection, 0x0000 /* Direction of next head step */
/* 0 = in, 1 = out (DIRTN) */
.equ rdDataFrom0, 0x0001 /* Set up drive to read data from */
/* head 0 (RDDATA0) */
.equ diskInserted, 0x0002 /* Disk inserted */
/* 0 = yes, 1 = no (CSTIN) */
.equ rdDataFrom1, 0x0003 /* Set up drive to read data from */
/* head 1 (RDDATA1) */
.equ stillStepping, 0x0004 /* Drive is still stepping */
/* 0 = yes, 1 = no (STEP) */
.equ writeProtected, 0x0006 /* Disk is locked */
/* 0 = yes, 1 = no (WRTPRT) */
.equ drvMotorState, 0x0008 /* Drive motor is on */
/* 0 = yes, 1 = no (MOTORON) */
.equ singleSided, 0x0009 /* Drive is single-sided */
/* 0 = yes, 1 = no (SIDES) */
.equ atTrack00, 0x000A /* Head is at track 00 */
/* 0 = yes, 1 = no (TK0) */
.equ headLoaded, 0x000B /* Head loaded, drive is ready */
/* 0 = yes, 1 = no () */
.equ drvInstalled, 0x000D /* Disk drive installed */
/* 0 = yes, 1 = no () */
.equ tachPulse, 0x000E /* Tachometer pulse (60 /rev.) */
/* 0 = yes, 1 = no (TACH) */
.equ diskIsHD, 0x000F /* HD disk detected */
/* 0 = yes, 1 = no (DRVIN) */
/* Commands */
.equ stepInCmd, 0x0000 /* Head step direction in (DIRTN) */
.equ stepOutCmd, 0x0001 /* Head step direction out (DIRTN+1) */
.equ doStepCmd, 0x0004 /* Step head (STEP) */
.equ motorOnCmd, 0x0008 /* Switch drive motor on (MOTORON) */
.equ motorOffCmd, 0x0009 /* Switch drive motor off (MOTOROFF) */
.equ ejectDiskCmd, 0x000D /* Eject disk from drive (EJECT) */
/*
* Low level disk errors
* For simplicity, they are given the MacOS names and numbers.
*/
.equ noErr, 0 /* All went well */
.equ noDriveErr, -64 /* Drive not installed */
.equ offLinErr, -65 /* R/W requested for an offline drive */
.equ noNybErr, -66 /* Disk is probably blank */
.equ noAdrMkErr, -67 /* Can't find an address mark */
.equ dataVerErr, -68 /* Read verify compare failed */
.equ badCkSmErr, -69 /* Bad address mark checksum */
.equ badBtSlpErr, -70 /* Bad address mark (no lead-out) */
.equ noDtaMkErr, -71 /* Could not find a data mark */
.equ badDCkSum, -72 /* Bad data mark checksum */
.equ badDBtSlp, -73 /* One of the data mark bit slip */
/* nibbles was incorrect. */
.equ wrUnderRun, -74 /* Could not write fast enough to */
/* keep up with the IWM */
.equ cantStepErr, -75 /* Step handshake failed during seek */
.equ tk0BadErr, -76 /* Track 00 sensor does not change */
/* during head calibration */
.equ initIWMErr, -77 /* Unable to initialize IWM */
.equ twoSideErr, -78 /* Tried to access a double-sided disk */
/* on a single-sided drive (400K drive) */
.equ spAdjErr, -79 /* Can't adjust drive speed (400K drive) */
.equ seekErr, -80 /* Wrong track number read in a */
/* sector's address field */
.equ sectNFErr, -81 /* Sector number never found on a track */
.equ fmt1Err, -82 /* Can't find sector 0 after */
/* track format */
.equ fmt2Err, -83 /* Can't get enough sync */
.equ verErr, -84 /* Track failed to verify */
