#
#       $NetBSD: HADES.in,v 1.17 2022/12/22 11:05:55 nat Exp $
#
# Medusa-Hades
#
# This configuration file is for a generic Medusa-Hades
#

#include "GENERIC.in"

pseudo-device   view    4       # View (graphics mapping)
pseudo-device   mouse   1       # mouse

#
# The following sections describe various hardware options.
#

ncrscsi0        at mainbus0     # NCR5380 SCSI driver
scsibus0        at ncrscsi0     # SCSI bus
zs0             at mainbus0     # Serial support through 8530
nvr0            at mainbus0     # nvram driver
lp0             at mainbus0     # centronics printer
ser0            at mainbus0     # UART on first 68901 (ttyB0)
grfbus0         at mainbus0     # bitmapped display's
grfet0          at grfbus0      # et4000/et6000/et6100 consoles
ite0            at grfet0
grfet1          at grfbus0
ite1            at grfet1
grfet2          at grfbus0
ite2            at grfet2
pcib0           at mainbus0     # PCI-bus
pci0            at pcib0
# wsdisplay/keybd: if used, remove grfbus* grfet* and ite*
#vga0           at pci? dev ? function ? # a PCI VGA card
#wsdisplay*     at vga? console ?       # as a wscons console
#wskbd0         at kbd0 console ?       # Keyboard
avmebus0        at mainbus0     # VME bus
vme0            at avmebus0
le0             at vme0 irq 5   # Lance ethernet (Riebl/PAM).
le0             at vme0 irq 4   # Lance ethernet (BVME410).
et4k0           at vme0         # Crazy Dots II
isab0           at mainbus0     # ISA-bus
isa0            at isab0
wdc0            at mainbus0     # IDE-bus
atabus*         at wdc? channel ?
wd*             at atabus? drive ?
# ATAPI bus support
atapibus*       at atabus?

# ATAPI devices
cd*     at atapibus? drive ?            # ATAPI CD-ROM drives

# SCSI devices
sd*     at scsibus? target ? lun ?      # SCSI disk drives
st*     at scsibus? target ? lun ?      # SCSI tape drives
cd*     at scsibus? target ? lun ?      # SCSI CD-ROM drives
#if !defined(SMALL030_KERNEL)
ch*     at scsibus? target ? lun ?      # SCSI autochangers
ss*     at scsibus? target ? lun ?      # SCSI scanners
dse*    at scsibus? target ? lun ?      # SCSI ethernet (Dayna)
se*     at scsibus? target ? lun ?      # SCSI ethernet
uk*     at scsibus? target ? lun ?      # SCSI unknown
#endif /* SMALL030_KERNEL */

#if !defined(SMALL030_KERNEL)
# Networking...
ne0     at isa0 port 0x300 irq 5        # NE2000 ethernet

#endif /* SMALL030_KERNEL */