ZERO GRAVITY TOILET

PASSENGERS ARE ADVISED TO READ INSTRUCTIONS BEFORE USE

1   This toilet is of the standard zero-gravity type. Depending on
   requirements, system A and/or system B can be used, details of which are
   clearly marked in the toilet compartment. When operating system A, depress
   lever and a plastic dalkron eliminator will be dispensed through the slot
   immediately underneath. When you have fastened the adhesive lip, attach
   connection marked by the large "X" outlet hose. Twist the silver coloured
   ring one inch below the connection point until you feel it lock.

2   The toilet is now ready for use. The Sonovac cleanser is activated by the
   small switch on the lip. When securing, twist the ring back to its
   initial-condition, so that the two orange lines meet. Disconnect. Place the
   dalkron eliminator in the vacuum receptacle to the rear. Activate by
   pressing the blue button.

3   The controls for system B are located on the opposite wall. The red
   release switch places the uroliminator into position; it can be adjusted
   manually up or down by pressing the blue manual release button. The opening
   is self-adjusting. To secure after use, press the green button which
   simultaneously activates the evaporator and returns the uroliminator to its
   storage position.

4   You may leave the lavatory if the green exit light is on over the door.
   If the red light is illuminated, one of the lavatory facilities is not
   properly secured. Press the "Stewardess" call button to the right of the
   door. She will secure all facilities from her control panel outside. When
   green exit light goes on you may open the door and leave. Please close door
   behind you.