Subj : questions from noob
To   : Nick Andre
From : August Abolins
Date : Wed Feb 12 2020 11:29 pm

Hi Nick,

I've been experimenting with D'Bridge for a little while now, and have run into
a few issues with it.  ;)

[1] When constructing a netmail message, it finds the relevant name with the
handy integration of the nodelist, but it changes the zone number to 1 if the
original address was written for a zone 2 or 3 destination.  Then, when the
program is queued/polling mode, it reports "no such address" for those messages
and sits on a Hold.

[2] What is the proper way to integrate the Z2PNT nodelist? I've tried just
adding it in the same section where the regular full NODELIST is recorded, but
the address lookups would then fail. As a consequence, a message to another
point address does not seem to be possible.

[3] I've adjusted the display size to about 40 lines, but when reading a
message that exceeds 40 lines, and scrolling down, the message content
"duplicates" for about 10 lines before the rest of the actual message shows up.


I have a few more questions, but those are the main ones.

--- D'Bridge 4
* Origin: Mans Mazais Eiropas D'Bridge Punkts (2:221/1.59)

You are viewing proxied material from cvs.synchro.net. The copyright of proxied material belongs to its original authors. Any comments or complaints in relation to proxied material should be directed to the original authors of the content concerned. Please see the disclaimer for more details.