Subj : Packet passwords
To : Nicholas Boel
From : Roger Nelson
Date : Sat May 28 2016 01:40 pm
On Sat May-28-2016 07:41, Nicholas Boel (1:154/10) wrote to Roger Nelson:
NB> On 28 May 16 05:50, Roger Nelson wrote to Nicholas Boel:
NB>> While I have limited ways to look at this unless I load DB up in
NB>> dosemu, I suppose it's easy enough to ask. Is there by chance a
NB>> "Session password" setting in the echomail section of DB's config
NB>> as well as a "Session password" setting in the BinkD config
NB>> section?
RN> The packet password setting is in Packet/mail control, while the
RN> session password setting is in another section under Security
RN> settings. Both areas are accesible from the main screen via the Esc
RN> key for the pull-down menus.
NB> My only question (and I asked Mark the same) is if there is any
NB> other binkd specific settings under that Security settings along
NB> with the session password?
I answered that above. Was I not clear? In case you didn't know, Nick made
his own version of BinkD and incorporated it into D'Bridge as BINKDWIN. There
is also an OS/2 version. Since many of us are running different operating
systems and configurations, it's almost impossible to tell what is going on at
someone else's system. Then there are the various spftware programs in use and
how they are run. I always have been an advocate of keeping things simple.
NB> A session password should only be handled by the mailer. So is
NB> there a way in DB to edit specific binkd commands (like the actual
NB> "node" line where the session password should be placed) in DB?
Nick will have to answer that one to your satisfaction, I'm afraid. The setup
in D'Bridge is relatively simple, even for newbies.
Regards,
Roger
--- timEd/386 1.10.y2k+ Windows 10
* Origin: NCS BBS - Houma, LoUiSiAna - (1:3828/7)
