Subj : Re: Hakko FR-301
To : Dr. What
From : MRO
Date : Wed May 20 2020 08:40 pm
Re: Re: Hakko FR-301
By: Dr. What to MRO on Tue May 19 2020 10:19 am
> Lesson learned: I still need to have a soldering iron near by to heat up the
> area a bit to remove the component. But the desoldering tool make removing
> that component 100 times easier than with manual only tools.
i'm old school. i prefer manual. my coworkers are crying for a 'solder sucker'
but me and the boss are very against them. those pads are just on with a bit of
glue.
when you do the tool, you go over the lead and go down and do a little
wiggle. then you go up and suck. atleast that's how i was shown. i only ripped
off one pad and it was because of the issue you mentioned where i didnt get all
the solder off and i ripped it off.
i still like the old school desoldering methods. i feel like i have a lot more
control.
---
� Synchronet � ::: BBSES.info - free BBS services :::