Subj : 3d printing
To : Ernest J Gainey Iii
From : echicken
Date : Sun Aug 11 2019 06:37 pm
Re: 3d printing
By: Ernest J Gainey Iii to echicken on Sun Aug 11 2019 17:56:56
EJ> I'll be getting a new glass plate, so I'll have to adjust the nozzle
If a spring-steel sheet is available for your printer, I'd recommend trying it. Makes it extremely easy
to lift prints off of the bed once they're done. (This is standard with the i3.)
EJ> I'm also getting an octaprint kit tomorrow, that should be fun the play
EJ> with. (Could have set one up myself, but figured a pre-configured kit was easier and not that expens
I have an OctoPi set up. It's been useful, especially since the printer is on the other side of the room
from my desk (I wouldn't trust a USB cable that long, nor do I want to shuffle SD cards around). Remote
monitoring and timelapse videos are fun extras, and there are some other useful plug-ins.
