Subj : Change of prt number for mbse
To   : All
From : Vincent Coen
Date : Fri Feb 04 2022 11:11 pm

Hello All!

I want to run a second version of mbse on a Raspberry Pi with a USB connected
1Tb Sata HDD as a back up system but more likely to just run the elist
software.  This way I can having set it up pass on the elist batton to some
one
else as a total system as all it needs is LAN cable to router or hub, HDMI
cable for a monitor and if needed a two wire power cable (using a 8 socket)
for power.  Now it can work any where in the world as the power adaptor is one
for a Laptop with a voltage range of 100 - 240.
The benefit of this is that it is very low power requirement although it
should
be connected to a UPS if at all possible (and yes my kit does even if only
good for around a hour).

Now as the primary BBS uses the standard port 24554 I would like it to use
24555.

This way I can tell the Router to port forward 24554 to pass all traffic to
the
primary and if a poll comes in using 24555 to pass traffic to the Pi.

I cannot see how you set up the port in mbse and I think I have looked every
where (unless some one knows otherwise by doing a search of the manual for
'24554')  as it looks like 24554 is the standard and can't be changed - or can
it ?





Vincent
--- Mageia Linux v8 X64/Mbse v1.0.7.24/GoldED+/LNX 1.1.5-b20180707
* Origin: Air Applewood, The Linux Gateway to the UK & Eire (2:250/1)

You are viewing proxied material from vert.synchro.net. The copyright of proxied material belongs to its original authors. Any comments or complaints in relation to proxied material should be directed to the original authors of the content concerned. Please see the disclaimer for more details.