++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+ +
+ (> Night Crawler <) +
+ Proudly Presents: +
+ January 25, 1986 +
+ THE ANARCHY FILES ... VOLUME III +
+ "Bigger And Better" +
+ A.O.A. RADIO PRODUCTIONS +
+ +
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
* As in Manual I & II, I am in no way responsible for any damages,
* accidents or injuries incurred while working on an experiment from this
* Manual. I didn't make you do these experiments, and as far as I am
* concerned, this is for information only.
Chapter IV: Gasoline
Undoubtedly you have messed with gasoline before. This is really some
flammable and useful shit. The peculiar thing about it though, is it can
catch almost anything on it on fire except for the thing that the gasoline
is sitting on. For example, wet a rag and cover it in gasoline and light
up. After all the gasoline is burned away, notice the rag is still wet.
Nothing happened at all to the rag. If you stuck a firecracker on the rag
while it was burning though, the firecracker would have went off.
Recently, as I have a pool and this is the winter months, I had a great
chance to see the effects of certain things on ice. A pick-axe does a great
job at getting you soaking wet, because as I was chopping away, the island
of ice under me decided to sink and it was about 20 below. The water was
very stagnant as it was sitting for a few months, and you could essentially
call it liquid fart. This is the kind of water to use as a replacement for
"Stinkum" (You can find that recipe on almost any BBS).
But anyway, I started out by trying out a recipe from someone
that said how to make plastique out of gas, oil, and styrofoam. Wanting to
make some fool look like a complete asshole, I tried it, and as it turned
out, it made him look like a complete asshole. The only thing it does is
give the gasoline a base to melt through the ice without getting soaked.
Dont even bother trying to make "C-4" from gas and oil. Chances are the oil
wont light anyway unless its mixed thoroughly with the gasoline.
Molotov Cocktail:
Ingredients:
pepsi Bottle
Old Rag (not a tampon, a cotton rag)
joy detergent (optional)
light weight oil (optional)
This is one of the simplest make-do bombs that you can make. It doesn't
explode like some 10 year olds think, but when it busts it makes one hell
of a fire.
Just fill the bottle up with 3/4 gasoline, and any joy or oil you might
want to add, and stuff the rag in. Wait 5 minutes for the gas to soak up
into the cloth (Cotton is suggested). All you have to do is light it and
throw it in a window, or in your pool, or where ever a flame would please
you.
Gasoline isn't a great thing to start off explosives though. You could
pour it on an m-80 and chances are the m-80 wouldn't go off when you lit
it. Of yes, remember that gasoline evaporates at a very low temperature. If
you put some in a milk jug and light the rim, you will probably get a 2
foot flame from the vapors.
Napalm for fun:
3 parts gasoline
1 part Joy Dish soap
Just mix together and the dish soap will burn steadily for quite a time.
You can also melt certain bar soaps into heated gasoline, but this
evaporates your gas so I dont like it. This is good for a filler in your
Basic Molotov cocktail.
Chapter V: Roly Poly match heads...
Match heads are your everyday pre-made explosives. Everytime you light one
you can see how powerful they are. One small head fills up about 250 times
its volume in flame and about an additional 75 more in smoke.
You can see the increase in power by putting about 5 or 10 matches
together and lighting them. Its not much of an increase if they are right
next to each other but it has a tremendous gain in temperature.
Here is an interesting conceipt as written by the /\/\aster.
Ingredients:
Tennis ball
A few scores of matches
sharp knife
Take the knife and slice into the tennis ball. Make sure that the slot is
big enough to pour match heads in. The smaller the tennis ball the faster
it will be to make the bomb. Start cutting match heads off the matches
with a razor or the knife and pour into a cup. After you get about 5 packs
dump them into the tennis ball. Do this until the tennis ball is packed
tight. If you have it as tight as you can, and the matches are the so
called "safety" kind, then throw it high into the air and run. As it
touches the ground it will explode with a great flame. If that doesnt work
then you have to try something else. Just make the slot about a 1/4" wide
and put in a pile of gunpowder and a small fuse. You can just light the
fuse and stand back. The tennis ball will send forth a column of flame and
flaming projectiles (match heads) about three feet in the air. It's Great!
You can probably think of a thousand places to use these babies...
Chapter VI: Time Delay Fuses
You are probably going to need this for when you decide to do bombs in
bathrooms (then you'll really be smokin' in the boys room). You want the
bomb to go off (preferably) when you are in the deans office. Here is one
from an old bulletin board message:
one straw
glycerin
Just wrap your fuse around the bottom of the straw, plug the other end
with non-absorbant fabric (thick cotton) and fill the straw with the
glycerin. Light the top and it will burn down slowly. You should have
enough time to get out of there quickly without anyone noticing.
There is an alternative to this using electronics. Any idiot can make
this...
Materials:
Solar Ignitor
9v Battery
3 flexible wires
a push button switch
a 9v battery clip
This is one of the easiest things you can make. Just connect two wires to
the switch, one leading to the battery clip, the other to one lead of the
solar ignitor. Connect the third wire from the solar ignitor to the other
lead of the battery clip and then plug in the battery. Just attach the
solar ignitor to the fuse of whatever you want to blow up and whenever
someone presses or steps on the switch, KA-BLOOIE. The solar ignitors can
be found at Toys 'R' Us and the rest at Radio Shack. If this circuit cant
light tough fuses, then pack a few match heads around the solar ignitor for
a good flame.
How to make a Welcome mat Detonator:
You can also make a welcome mat detonator with this circuit. Just
cut two pieces of cardboard that will fit under your "friend's" welcome
mat. Flue tin foil to one piece, enough to cover it, and solder a wire to
it. That is your first lead. Take a wire with about 2 inches stripper from
it and poke it throught the center of the other piece, and poke it back
out the top about a half inch away (much like you are trying to sew the
cardboard with the wire). Now stick some foam rubber or carpet padding on
the corners of the tin-foil coated cardboard, and glue the other piece of
cardboard to it. You should now have two pieces of cardboard parallel to
each other separated by 4 foam rubber pads at the corners. Make sure the
Wire and the tin foil cardboards aren't touching! That will close the
circuit and as soon as you connect the batter your solar ignitor will go
off. Just slip under his welcome mat at night and either ring and run, or
pull his knocker with a string from across the street. Obviously, you
should have some type of explosives or fireworks attached to his screen
door.
Chapter VII: Land Mines
I'm not sure who really wrote this file although I think it's from the
Poor Man's James Bond by Kurt Saxon. It's very simple. Just take a thick
toilet paper tube, dip one end in wax until it's sealed thick and stuff
papers or pour very hard glue into that end from the other side of the tube
and after you are sure it's sealed fill it with gunpowder. You might want
to put a hole for a fuse through the center of the tube (Its a lot easier
to detonate if you have a fuse). Then pour some elmers glue on top of the
gunpowder, after it dries pour a layer of crazy glue, then another layer of
elmers glue, and then dip it in wax. Wallah, instant M-80. All you have to
do after that is attach your solar ignitor from the electronic fuse and put
it in some type of packaging. Bury a half inch below the ground and stick
the switch in the ground about three feet ahead of it. Whenever the
neighborhood kids come in your yard again, well you can imagine what
happens.
Chapter VII: Iodine Explosive
A big asshole in your school who
beats up hall monitors comes over and rapes your girlfriend. Well, for
those times that M-80's and land mines are inappropiate or just wont work,
I bring you iodine explosives...
Ammonium triiodine: (also known as nitrogen triiodine)
Iodine crystals
Liquid ammonia
Mr. coffee filter papers
Stir the iodine crystals into the ammonia at a 1:5 basis. After a few
minutes with stirring you should see solids beginning to form. Filter this
out and mix with 1/2 its own volume in water to store. This is highly shock
sensitive. A leaf could set it off and some assholes foot on his locker
will do it too. One crystal is supposedly equivalent to a firecracker and
there is in the neighborhood of 200 crystals in a teaspoon. To use just
stick in a pop can and spill all over in front of his locker and when it
dries, it is so fucking explosive it isn't funny.
So don't let it dry on you! To test this out try it with 2 grams of Iodine
amd 10 ml of ammonia and just throw a brick or a rock on it somewhere.
Chapter VIII: Smoke
Smoke is very useful sometimes. you can use it to disrupt class, fool
people into thinking its a fire, get rid of some cops on your tail, or any
of a # of things. Chances are you may have already made a smoke bomb...
Easy smoke bomb:
Gunpowder
Pipe with one end capped
fuse or soiled rag (Author's note: This may explode when placed
in a pipe and burned. Just do it in a bowl.)
Fill the pipe with gunpowder but dont pack it down really tight. Make
sure there are air pockets in there. Then stick your fuse into the
uncapped end and light. You should have smoke piling out of there like
crazy.
another easy way to get smoke is with castor or motor oil. A few drops of
these make a tremendous amount of thick black smoke. One method uses it to
its advantage:
Smoke screen for your car...
Run a rubber tubing into your exhaust manifold from the drivers
compartment. Find a bottle with a small neck that will fit the hose on
the drivers compatment and fill it with motor oil or castor oil.
Whenever you are getting a high speed chase, just insert the bottle into
the hose. If your hose is too small, you will have to use a plastic
squeeze bubble or drill a hole into the other end of the bottle and cork
it. When you uncork it, air can get in and the oil will go down the
tubing to the red hot exhaust manifold, burn, and make a lot of smoke.
Sometimes you dont want smoke, you want a smokeless flame. That is not-
so-easily accomplished with the following recipe:
Materials: (By Zaphod Beeblebrox)
70ml concentrated sulphuric acid
30ml concentrated nitric acid
5g absorbant cotton
250ml sodium bicarbonate
250ml beaker
Ice bath
Tongs
Paper towels
Place 250ml beaker in the ice bath, add 70ml sulphuric acid, 30 ml
nitric acid. Divide cotton into .7g pieces. with tongs, immerse each
piece in the acid solution for 1 minute. Next, rinse each piece in 3
sucessive baths of 500 ml water. Use fresh water for each piece.
Then immerse in 250ml sodium bicarbonate. If it bubbles rinse in water
once more until no bubbling occurs. Squeeze dry and spread on paper towels
to dry overnight. (Reprinted exactly as I have never tried this).
This concludes anarchy 3. In the next manual we will get into plastic
Explosives, and in anarchy 5 I will get into RDX, TNT, and
nitroglycerin. Anarchy 6 will deal with how to use these explosives.
+--------------------------+
! Brought to you by Matrix ! Again, due to age, this file has been
! Call The Surf Board ! edited by me. Also, I never got ahold
! (412)/785-DATA ! of Anarchy 4-6, if they ever existed.
+--------------------------+
